The Vault
Troubleshooting guide
Why does my die-cut drift out of register with the printed image partway through the run?
Posted by the SuperPrinters team · 7/26/2026
The die-cut outline sits centered on the print at the start of the job but gradually shifts relative to the printed image as the run continues, often after 20-30 minutes. Labels end up cut off-center or clipping the artwork. Most often caused by tension drift between the print engine and the die station stretching or relaxing the web, especially on thin films, among other possible causes — a full step-by-step diagnostic and fix follows below.
+ Content, Copyright & Attribution

SuperPrinters respects original work and believes creators deserve recognition. We make reasonable efforts to ensure that content referenced, reproduced, or contributed to SuperPrinters is either appropriately authorised, copyright-free, or credited to its original source.

Contributors are expected to confirm that they have the right to share the material they submit, that it has been sourced ethically with any necessary permissions, and that it may be used to improve SuperPrinters’ content and answers.

Despite our efforts, an attribution may occasionally be missing, incomplete, or incorrect. If you are a creator, copyright owner, or become aware of any content that you believe has been used without appropriate permission or credit, please report it to us. We will review the matter promptly and, where appropriate, add or correct the attribution, modify the content, or remove it.